Glove-Sleeve System
The glove sleeve system consists of a cuff that is attached to a glove using an adapter ring. The cuff and glove materials can be combined according to requirements. If the glove is damaged, it can be replaced, while the cuff can still be used. The total length of the glove sleeve system is approx. 800 mm.
We offer the following protective gloves for the system:
Jugitec B 03/05/07
- Version: rough and smooth
- Size: 7 / 8 / 9 / 10 / 11
- Length: 350 mm
- Hand shape: fully anatomical
- WandWall thicknesses: 0,3 / 0,5 / 0,7 mm
Jugitec BV 03/07
- Version: smooth
- Size: 7 / 8 / 9 / 10 / 11
- Length : 300 / 350 mm
- Hand shape: fully anatomical
- Wall thicknesses: 0,3 / 0,7 mm
Jugitec H (0,4 mm)
- Version: smooth
- Size: 9 / 10
- Length : 350 mm
- Hand shape: fully anatomical
- Wall thicknesses: 0,4 mm
We offer the following cuffs for the system:
Jugitec H
- Wall thicknesses: 0,4 mm
- Length: 520 mm
- rolled edge: on the port side
- Wrist port diameter: 90-100mm
- Port diameter shoulder: on request
Jugitec B
- Wall thicknesses: 0,4 mm
- Length: 520 mm
- rolled edge: on both sides
- Wrist port diameter: 90-100mm
- Port diameter shoulder: on request
Jugitec ISOflex
- Wall thicknesses: 0,5 mm
- Length: 520 mm
- rolled edge: on both sides
- Wrist port diameter: 90-100mm
- Port diameter shoulder: on request
Adapter Ring
- Material: POM
- Dimensions inside: 10,0 cm
- Dimensions outside: 11,0 cm
- Height:4 cm
O-Ring
- Material: EPDM
- Measurements: 85x5 mm
Mounting instructions
1.
Slide the adapter ring from the large diameter into the cuff until the rolled edge of the small diameter sits on the 1st groove of the adapter ring.
2.
The rolled edge of the cuff sits firmly in the 1st groove of the adapter ring.
3.
Position the rolled edge of the glove in the 3rd groove of the adapter ring.
4.
Clamp the O-ring onto the center groove of the adapter ring. The glove sleeve system is ready for use.
